Filter
Top Products
Chapter 7 Troubleshooting 65
4. Save the edited file.
5. The next time you start WinView, the new name will be displayed on the
Hardware Setup dialog.
6. If you later re-run the Camera Detection Wizard, the name will be changed back
to the default name (i.e., Camera1.)
Changing the ST-133 Line Voltage and Fuses
The appropriate voltage setting for your country is set at the factory and can be seen on
the power module. If your voltage source changes, you will need to change the voltage
setting and you may need to change the fuse configuration.
Input
Voltage
Fuses
Type
Left
Right
100/120 V
AC
0.75 A
2.50 A
Slow Blow
220/240 V
AC
0.30 A
1.25 A
Slow Blow
Table 6. Fuse Ratings
Use proper fuse values and types for the controller and detector to be properly protected.
WARNING!