Filter
Top Products
6-12
C
HAPTER
6: C
ONFIGURING
THE
C
ORE
B
UILDER
7000 F
AMILY
ATM S
WITCH
Interface Type Section This section prompts you for the ATM
interface type configuration of the ports on the Interface Modules which
are installed in the CoreBuilder 7000 family ATM switch chassis.
There are three interface types: UNI, E-IISP and IISP. The UNI type is
normally used when an edge device is connecting to a switch, the E-IISP
type is normally used when connecting to another CoreBuilder 7000 or
9000 switch, and the IISP type is used to connect to a device which does
not recognize the E-IISP protocol used by the CoreBuilder 7000 family
ATM switch such as switches of other vendors.
To enter the interface type configuration:
1 At the NNI type of port prompt, enter the NNI type for the port you just
specified. Enter “U” for UNI, enter “E” for IISP, or enter “I” for IISP.
2 Repeat step 2 until you have specified the interface type for all of the
ports that are in the Corebuilder 7000 family ATM switch chassis.
Interface type
=-------------
NNI type of port <3.1> (U<NI>, E<IISP>, I<ISP>): U
NNI type of port <3.2> (U<NI>, E<IISP>, I<ISP>): U
NNI type of port <3.3> (U<NI>, E<IISP>, I<ISP>): U
NNI type of port <3.4> (U<NI>, E<IISP>, I<ISP>): U
NNI type of port <3.5> (U<NI>, E<IISP>, I<ISP>): E
NNI type of port <3.6> (U<NI>, E<IISP>, I<ISP>): U
NNI type of port <3.7> (U<NI>, E<IISP>, I<ISP>): U
NNI type of port <3.8> (U<NI>, E<IISP>, I<ISP>): U