Filter
Top Products
2
A
BOUT
T
HIS
G
UIDE
Conventions
Table 2 and Table 3 list conventions that are used throughout this guide.
How to use the Fast Setup procedure Chapter 6
Installing a redundant power supply Chapter 7
Installing a redundant switching module Chapter 7
How to troubleshoot your system Chapter 8
Hardware and protocol specifications Appendix A
Safety information Appendix B
Site Requirements Appendix C
Getting technical support Appendix D
Table 1
Information in this Guide (continued)
Table 2
Notice Icons
Icon Notice Type Description
Information note Information that describes important features or
instructions
Caution Information that alerts you to potential loss of data or
potential damage to an application, system, or device
Warning Information that alerts you to potential personal injury
Table 3
Text Conventions
Convention Description
Screen displays
This typeface represents information as it appears on the
screen.
Syntax
The word “syntax” means that you must evaluate the syntax
provided and then supply the appropriate values for the
placeholders that appear in angle brackets. Example:
To enable RIPIP, use the following syntax:
SETDefault !<port> -RIPIP CONTrol =
Listen
In this example, you must supply a port number for <port>.
Commands
The word “command” means that you must enter the
command exactly as shown and then press Return or Enter.
Commands appear in bold. Example:
To remove the IP address, enter the following command:
SETDefault !0 -IP NETaddr = 0.0.0.0