Filter
Top Products
4-12
C
HAPTER
4: I
NSTALLING
AND
C
ONNECTING
C
ORE
B
UILDER
M
ODULES
atmForumNetworkManagement.
atmLanEmulation.
elanMIB.
elanLecsGroup.
elanLecsConfGroup.
lecsConfTable.
lecsConfEntry.
lecsAtmAddrSpec.
Press start query. The LECS order list is displayed on the bottom window.
20
Close the Backbone and Services Select window.
21
Open the Backbone and Services Select window again and use it to check
that the LECS database is correct.
This item could be done through the LMA but it is preferred to do so
through the NMS since the LMA will not show any redundant LES that
exists.
22
Reboot the switch using the LMA menu sequence: (1) SYS / (7) RBO. The
purpose of this step is to make the second card active in order to check
the LANE services there.
23
After the second switch module boots, verify connectivity with the NMS
station as in step 8).
24
Perform step 19) and 20) to verify LECS order.
25
Open the Backbone and Services Select window again and use it to check
the LECS database is correct.
The hardware and LANE redundancy procedure is finished.