Filter
Top Products
Switch Module
4-11
7
Verify that the ELAN names in the LECS database are identical in both
switch modules. Use menu item (2) LEM/(1) LCS/(5) LNT to check that the
LECS database of the second switch includes the ELAN name of the first
switch. For example, Elan6666_0 - Elan6666_15
LANE Redundancy Setup
8
Verify connectivity between the switch module and the NMS station by
pinging the switch module from the NMS station.
9
Load the Transcend application and open the Wizard Tool from the
ATMvLAN tool bar
10
Open the Backbone and Services Window.
11
Configure the LECS order as desired and press the Apply button.
12
Configure the LECS database. Add all the primary and redundant ELAN
names desired to the LECS database and press Apply. Make a list of the
ELAN names you have selected. You will need them for setting up the
other switch module.
13
When finished, close the Backbone and Services window.
14
Wait one minute to allow the LECS order database to transfer to the
other switch module.
The LECS ELAN database does not transfer automatically.
15
Reboot the switch using the LMA menu sequence:
(1) SYS / (7) RBO.
The purpose of this step is to make the first switch module active in order
to set up the LANE services there.
16
After the first switch boots, check its connectivity with the NMS station as
in step 8).
17
Perform steps 10) and 12) using the same list of ELANs.
18
Wait one minute.
Verifying LANE Redundancy Setup
19
Use the MIB browser under the Transcend tools menu and browse
through the MIB to verify that all the information regarding the LECS
order list has been transferred correctly.
Look in the following MIB location:
private.
enterprises.
atmForum.