Filter
Top Products
Chapter 45 Configure Clone
MGS3700-12C User’s Guide
410
The following table describes the labels in this screen.
Table 146 Management > Configure Clone
LABEL DESCRIPTION
Source/
Destination
Port
Enter the source port under the Source label. This port’s attributes are
copied.
Enter the destination port or ports under the Destination label. These are
the ports which are going to have the same attributes as the source port.
You can enter individual ports separated by a comma or a range of ports by
using a dash.
Example:
• 2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports.
• 2-6 indicates that ports 2 through 6 are the destination ports.
Basic
Setting
Select which port settings (you configured in the Basic Setting menus)
should be copied to the destination port(s).
Advanced
Application
Select which port settings (you configured in the Advanced Application
menus) should be copied to the destination ports.
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.