ZyXEL Communications metrogigabit switch Plumbing Product User Manual


 
Chapter 38 Maintenance
MGS3700-12C User’s Guide
361
Alternatively, click Save on the top right-hand corner in any screen to save the
configuration changes to the current configuration.
Note: Clicking the Apply or Add button does NOT save the changes permanently. All
unsaved changes are erased after you reboot the Switch.
38.4 Reboot System
Reboot System allows you to restart the Switch without physically turning the
power off. It also allows you to load configuration one (Config 1) or configuration
two (Config 2) when you reboot. Follow the steps below to reboot the Switch.
1 In the Maintenance screen, click the Config 1 button next to Reboot System to
reboot and load configuration one. The following screen displays.
Figure 186 Reboot System: Confirmation
2 Click OK again and then wait for the Switch to restart. This takes up to two
minutes. This does not affect the Switch’s configuration.
Click Config 2 and follow steps 1 to 2 to reboot and load configuration two on the
Switch.
38.5 Firmware Upgrade
Make sure you have downloaded (and unzipped) the correct model firmware and
version to your computer before uploading to the device.
Be sure to upload the correct model firmware as uploading the
wrong model firmware may damage your device.