Filter
Top Products
Chapter 3 Hardware Overview
MGS3700-12C User’s Guide
39
3 Pull the transceiver out of the slot.
Figure 11 Removing the Fiber Optic Cables
Figure 12 Opening the Transceiver’s Latch Example
Figure 13 Transceiver Removal Example
3.1.4 Management Port
The MGMT (management) port is used for local management. Connect directly to
this port using an Ethernet cable. You can configure the Switch via Telnet or the
web configurator.
The default IP address of the management port is 192.168.0.1 with a subnet mask
of 255.255.255.0.
3.1.5 Power Connector
Make sure you are using the correct power source as shown on the panel and that
no objects obstruct the airflow of the fans.
Use the following procedures to connect the Switch to a power source after you
have installed it.
Note: Check the power supply requirements in Chapter 47 on page 419, and make
sure you are using an appropriate power source.
Keep the power supply switch and the Switch’s power switch in
the OFF position until you come to the procedure for turning on
the power.