Filter
Top Products
Chapter 21 Policy Rule
MGS3700-12C User’s Guide
223
21.3 Viewing and Editing Policy Configuration
To view a summary of the classifier configuration, scroll down to the summary
table at the bottom of the Policy screen. To change the settings of a rule, click a
number in the Index field.
Figure 104 Advanced Application > Policy Rule: Summary Table
Outgoing Select Send the packet to the mirror port to send the packet to the
mirror port.
Select Send the packet to the egress port to send the packet to the
egress port.
Metering Select Enable to activate bandwidth limitation on the traffic flow(s) then
set the actions to be taken on out-of-profile packets.
Out-of-profile
action
Select the action(s) to be performed for out-of-profile traffic.
Select Drop the packet to discard the out-of-profile traffic.
Select Change the DSCP value to replace the DSCP field with the value
specified in the Out of profile DSCP field.
Select Set Out-Drop Precedence to mark out-of-profile traffic and drop
it when network is congested.
Select Do not drop the matching frame previously marked for
dropping to queue the frames that are marked to be dropped.
Add Click Add to inset the entry to the summary table below and save your
changes to the Switch’s run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are
done configuring.
Cancel Click Cancel to reset the fields back to your previous configuration.
Clear Click Clear to set the above fields back to the factory defaults.
Table 57 Advanced Application > Policy Rule (continued)
LABEL DESCRIPTION