Filter
Top Products
Chapter 17 Link Aggregation
MGS3700-12C User’s Guide
190
Criteria Select the outgoing traffic distribution type. Packets from the same source
and/or to the same destination are sent over the same link within the
trunk. By default, the Switch uses the src-dst-mac distribution type. If the
Switch is behind a router, the packet’s destination or source MAC address
will be changed. In this case, set the Switch to distribute traffic based on its
IP address to make sure port trunking can work properly.
Select src-mac to distribute traffic based on the packet’s source MAC
address.
Select dst-mac to distribute traffic based on the packet’s destination MAC
address.
Select src-dst-mac to distribute traffic based on a combination of the
packet’s source and destination MAC addresses.
Select src-ip to distribute traffic based on the packet’s source IP address.
Select dst-ip to distribute traffic based on the packet’s destination IP
address.
Select src-dst-ip to distribute traffic based on a combination of the
packet’s source and destination IP addresses.
Port This field displays the port number.
Group Select the trunk group to which a port belongs.
Note: When you enable the port security feature on the Switch and
configure port security settings for a port, you cannot include the
port in an active trunk group.
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 45 Advanced Application > Link Aggregation > Link Aggregation Setting
(continued)
LABEL DESCRIPTION