Filter
Top Products
Chapter 8 Basic Setting
MGS3700-12C User’s Guide
106
Note: The uplink port connected to the Internet should be the root port. Otherwise,
with smart isolation enabled, the isolated ports cannot access the Internet.
8.5 Switch Setup Screen
Click Basic Setting > Switch Setup in the navigation panel to display the screen
as shown. The VLAN setup screens change depending on whether you choose
802.1Q or Port Based in the VLAN Type field in this screen. Refer to the chapter on
VLAN.
Figure 43 Basic Setting > Switch Setup
The following table describes the labels in this screen.
Table 11 Basic Setting > Switch Setup
LABEL DESCRIPTION
VLAN Type Choose 802.1Q or Port Based. The VLAN Setup screen changes
depending on whether you choose 802.1Q VLAN type or Port Based
VLAN type in this screen. See Chapter 9 on page 117 for more
information.
Bridge Control
Protocol
Transparency
Select Active to allow the Switch to handle bridging control protocols
(STP for example). You also need to define how to treat a BPDU in the
Port Setup screen.