Filter
Top Products
Chapter 23 VLAN Stacking
MGS3700-12C User’s Guide
238
Priority Select a priority level (from 0 to 7). This is the service provider’s priority level
that adds to the frames received on this port.
"0" is the lowest priority level and "7" is the highest.”No change” do not change
the frame’s priority on this port.
Add Click Apply to save your changes to the Switch’s run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on
the top navigation panel to save your changes to the non-volatile memory
when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Index This is the number of the selective VLAN stacking rule.
Active This shows whether this rule is activated or not.
Name This is the descriptive name for this rule.
Port This is the port number to which this rule is applied.
VID This is the customer VLAN ID in the incoming packets.
SPVID This is the service provider’s VLAN ID that adds to the packets from the
subscribers.
Priority This is the service provider’s priority level in the packets.
Delete Check the rule(s) that you want to remove in the Delete column and then click
the Delete button.
Cancel Click Cancel to clear the Delete check boxes.
Table 65 Advanced Application > VLAN Stacking > Selective QinQ (continued)
LABEL DESCRIPTION