Filter
Top Products
Chapter 26 IP Source Guard
MGS3700-12C User’s Guide
285
26.6 ARP Inspection Status
Use this screen to look at the current list of MAC address filters that were created
because the Switch identified an unauthorized ARP packet. When the Switch
identifies an unauthorized ARP packet, it automatically creates a MAC address
filter to block traffic from the source MAC address and source VLAN ID of the
unauthorized ARP packet. To open this screen, click Advanced Application > IP
Source Guard > ARP Inspection.
Figure 136 ARP Inspection Status
The following table describes the labels in this screen.
Apply Click Apply to save your changes to the Switch’s run-time
memory. The Switch loses these changes if it is turned off or loses
power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done
configuring.
Cancel Click this to reset the values in this screen to their last-saved
values.
Table 86 DHCP Snooping VLAN Configure (continued)
LABEL DESCRIPTION
Table 87 ARP Inspection Status
LABEL DESCRIPTION
Total number of filters This field displays the current number of MAC address filters that
were created because the Switch identified unauthorized ARP
packets.
Index This field displays a sequential number for each MAC address
filter.
Mac Address This field displays the source MAC address in the MAC address
filter.
VID This field displays the source VLAN ID in the MAC address filter.
Port This field displays the source port of the discarded ARP packet.
Expiry (sec) This field displays how long (in seconds) the MAC address filter
remains in the Switch. You can also delete the record manually
(Delete).