Filter
Top Products
Chapter 32 PPPoE
MGS3700-12C User’s Guide
326
End VID Enter the highest VLAN ID you want to configure in the section below.
Apply Click Apply to display the specified range of VLANs in the section below.
VID This field displays the VLAN ID of each VLAN in the range specified above.
If you configure the * VLAN, the settings are applied to all VLANs.
* Use this row to make the setting the same for all VLANs. Use this row first
and then make adjustments on a VLAN-by-VLAN basis.
Note: Changes in this row are copied to all the VLANs as soon as
you make them.
Enabled Select this option to turn on the PPPoE Intermediate Agent on a VLAN.
Circuit-id Select this option to make the Circuit ID settings for a specific VLAN take
effect.
Remote-id Select this option to make the Remote ID settings for a specific VLAN take
effect.
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 110 Advanced Application > PPPoE > Intermediate Agent > VLAN (continued)
LABEL DESCRIPTION