Filter
Top Products
Chapter 32 PPPoE
MGS3700-12C User’s Guide
325
32.6 PPPoE IA for VLAN
Use this screen to set whether the PPPoE Intermediate Agent is enabled on a VLAN
and whether the Switch appends the Circuit ID and/or Remote ID to PPPoE
discovery packets from a specific VLAN. Click Advanced Application > PPPoE >
Intermediate Agent > VLAN to display the screen as shown.
Figure 164 Advanced Application > PPPoE > Intermediate Agent > VLAN
The following table describes the labels in this screen.
Remote-id Enter a string of up to 63 ASCII characters that the Switch adds into the
Agent Remote ID sub-option for PPPoE discovery packets received on this
VLAN on the specified port. Spaces are allowed.
If you do not specify a string here or in the Remote-id field for a specific
port, the Switch automatically uses the PPPoE client’s MAC address.
The Remote ID you configure for a specific VLAN on a port has the highest
priority.
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 109 Advanced Application > PPPoE > Intermediate Agent > Port > VLAN
(continued)
LABEL DESCRIPTION
Table 110 Advanced Application > PPPoE > Intermediate Agent > VLAN
LABEL DESCRIPTION
Show VLAN Use this section to specify the VLANs you want to configure in the section
below.
Start VID Enter the lowest VLAN ID you want to configure in the section below.