Filter
Top Products
Hardware-Related Messages 87
Hardware-Related
Messages
The XX package must have 20 MB of memory installed on the CEC or DPE
module. There is only 12 MB available.
Meaning: The bcmsysupgrade utility cannot continue because it does not detect
a CEC 20 or DPE in the system. The software package requires a
CEC 20 or DPE module.
Action: If you have a CEC 20 module, run the Memory Expansion Board utility
supplied with the memory upgrade by putting the diskette in the
floppy drive and entering bt memupgrd.29k. The program updates
the EPROM.
The hardware configuration of this NETBuilder could not be confirmed.
Meaning: Your hardware may not support the software package you are
upgrading to. The bcmsysupgrade script allows the upgrade to
proceed even if the hardware configuration is not recommended.
Action: Ensure that the bridge/router meets the hardware requirements for
the package you are upgrading to, and that it is on the recommended
upgrade migration path.
The NETBuilder hardware will not safely support the upgrade.
Meaning: The hardware is not sufficient to safely support the software upgrade,
and the bridge/router configuration is not on the upgrade migration
path.
Action: Contact your 3Com supplier for information about a hardware
upgrade.
Installation
Troubleshooting
Messages
The troubleshooting messages in this section are displayed during installation.
Installing the
Enterprise OS Upgrade
Management Utilities
Testing the Enterprise OS Upgrade Utilities installation.
Meaning: This is an introductory message displayed when the bcmdiagnose
utility is initiated.
Action: None.
There is a problem with the installation of the Enterprise OS Upgrade
Utilities. The path /usr/3Com/bcm/bin and usr/3Com/common/bin should
be in the PATH environment variable.
Meaning: The installation process has searched for certain utilities in
/usr/3Com/bcm/bin and /usr/3Com/common/bin directories but
cannot find them unless the path /usr/3Com/bcm/bin is first.
Action: Check that /usr/3Com/bcm/bin and /usr/3Com/common/bin have
been added in the path environment variable.
There is a problem with the installation of the Enterprise OS Upgrade
Utilities. The path /usr/3Com/bcm/bin should be first in the PATH
environment variable.
Meaning: The installation process cannot find the necessary directories unless
the path /usr/3Com/bcm/bin is first.
Action: Check that /usr/3Com/bcm/bin is first in the path environment
variable.