Filter
Top Products
Chapter 16: Diagnostic Console
291
Password setting Description
every password must have at least one digit in it.
Diagnostic Console Account Configuration
By default, the status account does not require a password, but you can
configure it to require one. Other aspects of the admin password can be
configured and the Field Support accounts can be enabled or disabled.
To configure accounts:
1. Choose Operation > Admin > DiagCon Passwords > Account
Configuration.
2. In the screen that appears, you can view the settings for each
account: Status, Admin, FS1, and FS2.
This screen is split into three main areas:
The top displays read-only information about the accounts on the
system.
The middle section displays the various parameters related and
pertinent to each ID, along with a set of buttons to allow the
parameters to be updated or new passwords provided for the
accounts.
The lower area restores the password configuration to Factory
Defaults (or to how the system was initially shipped).
3. If you want to require a password for the Status account, select
Enabled underneath it.
4. For the Admin and Status accounts, you can configure: