Filter
Top Products
Chapter 14: System Maintenance
200
Option Description
SNMP Trap Destinations
Default Firmware This option resets all device firmware files to factory defaults.
This option does not change the CC-SG database.
Upload Firmware to
Database After Reset
This option loads the firmware files for the current CC-SG version
into the CC-SG database.
Diagnostic Console This option restores Diagnostic Console settings back to factory
defaults.
IP-ACL Tables This option removes all entries from the IP-ACL table.
IP-ACL settings are reset with a Full Database reset whether you
select the IP ACL Tables option or not.
To reset CC-SG:
1. Before you reset, back up CC-SG and save the backup file to a
remote location. See Backing Up CC-SG (on page 194).
2.
Choose System Maintenance > Reset.
3. Select the reset options.
4. Type your CC-SG password.
5. Broadcast message: Type the message that will display to users who
will be logged off CC-SG.
6. Enter the number of minutes (from 0-720) that should elapse before
CC-SG performs the reset operation.
If specifying over 10 minutes, the broadcast message displays to
users immediately, and then repeats at 10 and 5 minutes before the
event occurs.
7. Click OK. A message appears to confirm the reset.
Do NOT power off, power cycle, or interrupt CC-SG when reset is in
progress. Doing this may result in the loss of CC-SG data.
Restarting CC-SG
The restart command is used to restart the CC-SG software. Restarting
CC-SG will log all active users out of CC-SG.
Restarting will not cycle power to the CC-SG. To perform a full reboot,
you must access Diagnostic Console or the power switch on the CC-SG
unit.
1. Choose System Maintenance > Restart.
2. Type your password in the Password field.