Filter
Top Products
Chapter 16: Diagnostic Console
275
4. Click Save.
Edit Network Interfaces Configuration (Network Interfaces)
In Network Interface Configuration, you can perform initial setup tasks,
such as setting the hostname and IP address of the CC-SG.
1. Choose Operation > Network Interfaces > Network Interface Config.
2. If the network interfaces have already been configured, you will see
a Warning message stating that you should use the CC-SG Admin
Client to configure the interfaces. If you want to continue, click YES.
3. Type your hostname in the Host Name field. After you save, this field
will be updated to reflect the Fully-Qualified Domain Name (FQDN),
if known. See Terminology/Acronyms (on page 2) for hostname
rule
s.
4. In the Mode field, select either IP Isolation or IP Failover. See About
Network Setup (on page 211).
5.
In the Configuration Field, select either DHCP or Static.
If you choose DHCP and your DHCP server has been configured
appropriately, the DNS information, the domain suffix, IP
address, default gateway, and subnet mask will be automatically
populated once you save, and you exit and re-enter Admin
Console.
If you choose Static, type an IP Address (required), Netmask
(required), Default Gateway (optional), Primary DNS (optional)
and Secondary DNS (optional), and Domain Name in Domain
Suffix (optional).