DMP Electronics XR500 Home Security System User Manual


  Open as PDF
of 84
 
Digital Monitoring Products XR500 Series Canadian Programming Guide
20
deviCe SeTuP
6.15.6
ACTIVATE ONBOARD
SPEAKER? NO YES
Activate Onboard Speaker
SelectYEStoenabletheonboardpiezospeakerforlocalannunciation.SelectNOto
turn the piezo off for all operations. This does not affect remote annunciator open
collector(RA)operation.ThedefaultisYES.
PresstheCOMMANDkeytodisplaytheCARDOPTIONSoption.TheBackArrow
returnstoACTIVATEZONE3REX.
6.15.7
CARD OPTIONS:
DMP
Card Options
Press any top row Select key to display options. Press the select key under DMP or
CUSTOMtoselectthatoption.SelectDMPtoindicatethereadersendsa26-bitDMP
datastring.PresstheCOMMANDkeytodisplayREQUIRESITECODE.
Note: When set to DMP, the 734 converts 17 bits of the 26-bit data string into a
5-digit number.
SelectCUSTOMifusinganon-DMPcardorusercodelengthof6to10digits.
Default is DMP.
6.15.8
WIEGAND CODE
LENGTH: 26
CustomCardDenitions
Whenusingacustomproduct,enterthetotalnumberofbitstobereceivedin
Wiegandcodeincludingparitybits.
PressanytoprowSelectkeytoenteranumberbetween0-255toequalthenumber
ofbits.Defaultis26bits.
Typically,anaccesscardcontainsdatabitsforasitecode,ausercode,andstart/
stop/paritybits.Thestartingpositionlocationandcodelengthmustbedetermined
andprogrammedintothe734Module.
01110101101101010001100111
First Bit
Received
Position = 0
Site Code
Position = 1
Length = 8
User Code
Position = 9
Length = 16
Last Bit
Received
Position = 25
In this example the Wiegand Code Length = 26 bits.
6.15.8.1 Site Code Position
Enter the site code start position in the data string. Press any top row Select
keytoenteranumberbetween0-255.Defaultis1.
6.15.8.2 Site Code Length
Enter the number of characters the site code contains. Press any top row
Selectkeytoenteranumberbetween1-16.Defaultis8.
6.15.8.3
USER CODE
POSITION: 9
User Code Position
DenetheUserCodestartbitposition.PressanytoprowSelectkeyto
enteranumberbetween0-255.Defaultis9.
6.15.8.4
USER CODE
LENGTH: 16
User Code Length
DenethenumberofUserCodebits.PressanytoprowSelectkeytoenter
acustomnumber.Customnumberscanonlybeanumberbetween16-32.
ThedefaultistheDMPvalueof16whichispre-programmed.
CARD OPTIONS:
DMP CUSTOM
SITE CODE
POSITION: 1
SITE CODE
LENGTH: 8
 previous next