DMP Electronics XR500 Home Security System User Manual


  Open as PDF
of 84
 
XR500 Series Canadian Programming Guide Digital Monitoring Products
19
deviCe SeTuP
6.15
PROGRAM 734
Program 734 Options
OPTIONS? NO YES
Select YES toprogramthe734WiegandInterfaceModule.Devicetypemustbesetto
DOOR.
6.15.1 Activate Zone 2 Shunt
SelectYEStoactivatetheSoft-Shunt™option.
SelectingNOallowsstandardzoneoperationonZone2anddisplaystheACTIVATE
ZONE3REXoption.DefaultsettingisNO.
Ifthedoorbeingreleasedbythe734moduleisprotected(contactinstalled),you
canprovideaprogrammableSoft-Shuntentry/exittimerbyconnectingitscontact
wiringtothe734moduleZone2.Whentheon-boardFormCrelayactivatesand
theuseropensthedoorconnectedtoZone2,thezoneisshuntedforthenumberof
secondsprogrammedinZONE2SOFTSHUNTTIMEallowingtheusertoenter/exit.
IfZone2doesnotrestore(doorclosed)withintheprogrammedtimeminusten
seconds, the piezo sounds every other second during the timer last ten seconds. If
Zone2restorespriortotheendoftheprogrammedtime,thepiezosilences.Ifthe
zonedoesnotrestoreafterthetensecondpiezotime,the734endstheshuntand
indicates the open or short zone condition to the panel.
IfyouselectYES,pressingtheCOMMANDkeydisplaysZONE2SOFTSHUNTTIME.The
BackArrowreturnstotheProgram734Options.
6.15.2
ZONE 2 SOFTSHUNT
TIME: 40
Zone 2 Soft-Shunt Time
EnterthenumberofSoft-ShuntsecondstoelapsebeforetheSoft-Shunttimer
expires. Range is from 20 to 250 seconds. Press any top row select key to enter the
numberofseconds.Ifthedoorremainsopenwhenthetimerexpiresazoneopen/
shortissenttothepanelforZone2.Thedefaultis40seconds.
PresstheCOMMANDkeytomoveforwardtoRELOCKONZONE2FAULT.TheBack
ArrowreturnstotheACTIVATEZONE2SHUNToption.
6.15.3
RELOCK ON ZONE 2
FAULT? NO YES
Relock on Zone 2 Fault?
SelectingNOleavestherelayonwhenZone2faultstoanopenorshortcondition
duringSoft-Shunt.SelectingYESturnstherelayoffwhenZone2faultsopenorshort
duringSoft-Shunt.ThedefaultisNO.
PresstheCOMMANDkeytodisplayACTIVATEZONE3REX:.TheBackArrowreturnsto
theZONE2SOFTSHUNTTIME:option.
6.15.4
ACTIVATE ZONE 3
REX? NO YES
Activate Zone 3 Request to Exit
SelectingYESactivatestheZone3RequesttoExit(REX)option.
SelectingNOallowsstandardzoneoperationonZone3anddisplaystheACTIVATE
ONBOARDSPEAKERoption.DefaultsettingisNO.
OptionallyconnectaPIR(orothermotionsensingdevice)oramechanicalswitchto
Zone3toprovideREXcapabilitytothesystem.WhenZone3shorts,theon-board
Form C relay activates for the programmed number of seconds. During this time,
theusercanopentheprotecteddoortostarttheprogrammedSoft-Shunt™entry/
exit timer. After the programmed number of seconds, the relay restores the door to
its locked state.
The734moduleprovidesashunt-onlyoptionforREXonZone3.WhenZone3opens
fromanormalstate,onlyaSoft-Shuntoccurs:theon-boardrelaydoesnotactivate.
Thisshunt-onlyoptionusestwomethodsofREX.TherstREXdeviceprovidesthe
programmedSoft-Shuntentry/exittimer.ThesecondREXdevice,ormanualdevice
such as a door knob, unlocks the door.
Anexampleoftheshunt-onlycongurationisadoortoanofcethatislocked24
hours a day. Users pass a REX motion detector positioned by the door to begin the
programmedexittimer.Withintheprogrammednumberofsecondstheusermust
then manually activate a second device, such as a REX device or manual door knob,
to unlock the door. If the door is opened after the programmed number of seconds,
the zone goes into alarm.
IfyouselectYES,pressingtheCOMMANDkeydisplaysZONE3REXSTRIKETIME.The
BackArrowreturnstotheACTIVATEZONE2SHUNToption.
6.15.5
ZN 3 REX STRIKE
TIME: 5
Zone 3 REX Strike Time
Enter the number of REX seconds to elapse. Range is from 5 to 250 seconds. Press
any top row select key to enter the number of seconds. The default is 5 seconds.
PresstheCOMMANDkeytomoveforwardtotheACTIVATEONBOARDSPEAKERoption.
TheBackArrowreturnstoACTIVATEZONE3REX.
ACTIVATE ZONE 2
SHUNT? NO YES
 previous next