Filter
Top Products
8. Getting started
Image 8-96
Saving the HUD position
A Status Information dialog will appear, click OK to save the new HUD position or the modified selected HUD position.
Image 8-97
Position HUD saved successfully
12.Repeat steps 5 to 11 to create additional positions if there are any remaining HUD image corners.
8.6.3.4 Creating Mask image
Introduction
While defining the AutoGeometry positions sometimes unwanted objects (e.g. mechanical object, fake corner(s), etc...) are visible
in the Camera Live view of that position. Those artifacts must be hidden as the AutoGeometry algorithm may detect them wrongly
as channel corners. This requires the user to create a mask using any design program: e.g. MS Paint, Adobe Photoshop, G imp,
Paint.NET.
The mask image resolution should be a little bigger than half of the camera resolution:
• Canon EOS 1000D: 1953 x 1301 pixels;
• Canon EOS 1100D: 2176 x 1437 pixels.
It must contain only black and white regions. A black region is used to hide the artifacts and the white regions of the mask will not
hide the image. All mask files must be saved as .png files at the following location on the MCU: C
:\Program Files\Barco\XDS\re-
sources\autoalign\maskImages
In case of XDS RACU Diskless serv
er, all mask files must be saved on a storage server provide by the customer at the following
location: \
\<MCU hostname>\shared_folder\<MAC address>\autoalign\maskImages where <MCU hostname> is the diskless MCU
server name, shared_folder is a folder on the diskless server and <MAC address> is the MAC address of diskless MCU server.
To know the MAC address o f your MCU co nnected o ver the n etwork, you may n eed to follow the steps mentioned below
1. Go to Start > Connect to > All Connections
2. Select your Local Area Connections right click it and select Status
3. In the Local Area Connection Status, select Support tab and click Details
4. The MAC address is the Physical Address listed in Network Connection Details.
R59770509 AUTOALIGNMENT HEAD GEN II 26/11/2013
89