Filter
Top Products
10. Operating Acuras
Pressing the Interrupt button stops the Acuras realignment process. The Gimbal returns to its home position
and the following confirmation dialog appears. The system will return to its previous situation and no data
will be lost.
Image 10-34
10.5 Undoing an Acuras realignment
Undoing an Acuras realignment (Undo changes)
While performing an Acuras realignment, it can happen that the result is not satisfactory. Pressing Undo changes overrides the
parameter changes saved during this Acuras realignment, ending up with the parameters of the previous realignment (or the initial
parameters of the active Golden Alignment if no previous realignment parameters are available), on condition that no other operation
has been performed since this last Acuras realignment.
An Undo changes feature can only be run once to returns to return to the previous realignment. Mu ltiple times
running the Undo changes feature can not return you any realignment d ata from the past.
Golden Alignment
“GA-01”
Parameters “P0”
stored in GA-01
Measurement “M0”
stored in GA-01
Capture
Meas. > Param (P1)
stored in GA-01
Realign
Meas. > Param (P2)
stored in GA-01
Realign
Meas. > Param (P3)
stored in GA-01
Realign
time
UNDO CHANGES
Image 10-35
Undo changes after Acuras realign
How to undo the Acuras Realign data?
1. Navigate to the A curas page and make either of the selections:
- If you wish to undo only on a selected set of
projectors, select the desired projectors or select all projectors in that group.
Image 10-36
Selecting the desired projector(s)
- select group, if you wish to run undo for all projectors of this group.
Image 10-37
Group selected
2. Press Undo Changes
128
R59770509 AUTOALIGNMENT HEAD GEN II 26/11/2013