Filter
Top Products
13. Operating OmniBlend
Image 13-9
Activating the position selection section
3. Select the OmniBlend position(s) where you wish to run the OmniBlend process.
Image 13-10
Selecting the position
4. Press Start
Image 13-11
Starting the OmniBlend process
5. In the appearing OmniBlend dialog:
- select the desired OmniBlend type: Colored blending or Grayscale blending.
-pressSelected positions to run the OmniBlend process for the selected OmniBlend positions.
-pressCan cel to abort the OmniBlend process.
Image 13-12
Note: Pressing the Interrupt button stops the O mniB lend process. The Gimbal returns to its original position.
The following confirmation dialog appears. The system returns to its p revious situation and no data is lost.
Image 13-13
Interrupting the OmniBlend process
Note: All pr ojectors that are not p art of any of the selected OmniBlend positions go to pause s tate.
Note: If OmniBlend positions were defined for different head locations, the user is prom pted to physically move the AutoAlign-
ment Hea d to the appropriate locations during the OmniBlend process.
A message appearing in the feedback section shows the progress information. It may take several hours to complete the Om-
niBlend process depending on the number of
positions selected.
13.5 Undoing an OmniBlend process
Undoing an OmniBlend process (Undo changes)
If the result of an OmniBlend process turns out to be poor for one or more blend regions (e.g. due to ambient light), the last saved
alpha plane on the concerned projector(s) can be restored if no other action was performed in the meantime (e.g. other projectors
selected, other group selected).
148
R59770509 AUTOALIGNMENT HEAD GEN II 26/11/2013