Filter
Top Products
4. Packaging
D Foam protection part
B
D
A
C
Image 4-4
Packaging: remove the foam parts (AutoAlignment Head rugged version)
A Foam protection part
B Second cardboard box
C AutoAlignment Head
D Foam protection part
4. Carefully cut the tape on the top lid of the second cardboard box
Warning: Follow the relevant safety precautions while using a knife.
5. Remove the parts from this box.
6. Check if all parts are available. See "Content", page 19.
4.3 Shipping bracket
Introduction
When the AutoAlignment Head is shipped, the shipping bracket must be fixed to it. This bracket prevents the Gimbal unit from
being damaged due to handling actions during shipment. The shipping bracket must be removed prior to installing the unit.
If this Au toAlignment Head must be shipped ever again, it is necessary to first install the shipping b racket.
Overview
• Removing the shipping bracket
• Installing the shipping bracket
22
R59770509 AUTOALIGNMENT HEAD GEN II 26/11/2013