Filter
Top Products
30
6.1.1 About floors, blocks, and groups
The G-50A system can target groups, operation blocks, floors, and the whole building.
In addition, for operation and monitoring, the name of the G-50A and the name of the building can be
registered.
Table 6-2 shows the setting registration and operation monitoring of each part while Table 6-3 shows the
characters that can be used for setting each registration screen.
●● What is a group?
This forms the standard of all operations and monitoring. In order to make sets including blocks and
floors, appropriate settings are required.
●● What is an operation block?
This term refers to a work unit consisting of a group of units.
In addition, in order to operate and monitor an operation block it is necessary to set it as a unit, while
it is also necessary to perf
orm the required settings in order to perform air conditioning charges.
●● What is a charge block?
This term refers to an apportionate electric power unit, when using the apportionate electric power
charge function.
For this block to be operated it must be organized as an operation block.
●● What is a floor?
This refers to one floor plan unit in the integrated TG-2000A software.
This unit is also required to be set as an operation group.
It is possible to set up to 55 floors. This does not refer to the number of floors but to the number of
floor screens.
●● What is the whole building?
This refers to all air-conditioning units controlled by the integrated TG-2000A software. This enables
operation only.
Group
Operation Block
Charge Block
Figure 6-1 Floors, blocks, and groups
Table 6-2 Setting table
Item
G-50A Main
Unit
Default Setting
Tool
Centralized
Control PC
(Web)
Centralized
Control PC
(integrated software)
Remarks
The operation block setting information set by
the default setting tool is saved to the G-50A
main unit, while the operation block saved by
the integrated software is saved to the PC.
Group of Operation block
Communication function for G-50A
(Installed in LAN) by using e-mail.
Exclusively for operation.
Blocks for operation or monitoring are
not available.
Exclusively for operation.
Exclusively for operation.
Exclusively for operation.
Operation, monitoring can be done only
from TG-2000A.
Group
Operation
block
Charge block
Floor
General purpose equipment
Malfunction e-mail
e-mail function
Group
Operation block
Charge block
Floor
Whole building
G-50A unit
General purpose
equipment
Setting, registrationOperation, monitoring