Filter
Top Products
Appendix 3. PLC Development Environment using GPPQ
3.6 PLC-Related Data Development Procedure
- 461 -
3.6.6 Transfer to the Controller
The following shows the method of transferring a message from the GPPQ to the CNC controller.
The transfer method is the same as that of the ladder code. Ladder codes and message data are
distinguished by their file names only.
(1) Menu Selection
The screen is selected from the menu using the following basic operation.
Mode screen
PC menu
window
２
A
lt ( GRPH )
２
Menu
PC
Write
PC menu
screen
(2) Screen Operation
Transfer is executed in the following screen.
An example of transferring a message 1st language file "M1TEST.GPG" is shown here.
[Write to PC]
Execute(Y)
Ctrl+L : filelist Ctrl+D : directo Space : sele Esc:close
Interface
Target PC
Target Mem
Cancel(N)
RS232C <---> QnACPU
Network : 0 Station : FF PC Type : Q4A
Internal RAM Title [ ON BOARD S-RAM + (D-RAM) ]
1. File 1. File Name [ ] Title [ ]
1. [ * ] Parameter
2. [ * ] Seq/SFC Prog
3. [ ] Device Comment
4. [ ] Dev Init Value
5. [ ] Simulation Data
6. [ ] File Register
1. [ ] Internal
1. ( * ) Whole Range
2. ( ) Step Range [ ] – [ ]
3. ( ) Step Range P [ ] – [ ]
4. ( ) Block Range [ ] – [ ]
1. ( * ) Whole Range
2. ( ) Specify ZR[ ] – [ ]
1. ( * ) Whole Range
2. ( ) Specify Detail Range
2. Device Mem
2. Tgt