Filter
Top Products
Appendix 3. PLC Development Environment using GPPQ
3.5 PLC Program Development Procedure
- 446 -
3.5.2 Ladder Transfer to the C64 Controller
The method of transferring a ladder to the C64 controller with the GPPQ (especially the restrictions
and C64 characteristic operations) is explained below.
(1) Menu Selection
The screen is selected from the menu using the following GPPQ basic operation.
( GRPH )
Mode screen
Menu
A
lt
PC
2
PC menu
window
2
Write
PC write
screen
(2) Screen Operation
The required options are selected and executed on the following screen.
[Write to PC]
Execute(Y)
Ctrl+L : filelist Ctrl+D : directo Space : sele Esc : close
Interface
Target PC
Target Mem
Cancel(N)
RS232C <---> QnACPU
Network : 0 Station : FF PC Type : Q4A
Internal RAM Title [ ]
1. File 1. File Name [ ] Title [ ]
1. [ * ] Parameter
2. [ * ] Seq/SFC Prog
3. [ ] Device Comment
4. [ ] Dev Init Value
5. [ ] Simulation Data
6. [ ] File Register
1. [ ] Internal
1. ( * ) Whole Range
2. ( ) Step Range [ ] – [ ]
3. ( ) Step Range P [ ] – [ ]
4. ( ) Block Range [ ] – [ ]
1. ( * ) Whole Range
2. ( ) Specify ZR[ ] – [ ]
1. ( * ) Whole Range
2. ( ) Specify Detail Range
2. Device Mem
2. Tgt
[Restrictions]
The following options of [2. Tgt] under [1. File] can be selected.
[1. Parameter]
[2. Seq/SPC Prog] and [1. Whole Range]
[3. Device Comment]
Note that nothing will be transferred even if [1. Parameter] is selected.