Filter
Top Products
6. Explanation of Commands
6.2 Command Formats
- 102 -
(2) When a digit is designated on the destination (D) side, the No. of points designated by the digit
will be the target of the destination side.
Circuit side Process
When source data (S) is a value
MOV H1234
K2M0
Destination (D) side
K2M0
00100011
M15‥‥‥‥‥‥‥‥M8 M7‥‥‥‥‥‥‥‥M0
Does not change
H1234
00 010 0 0 010100011
1234
34
When source (S) data is a bit device
MOV K1M0 K2M100
(Note）
Destination (D) side
K2M100
M115 ‥‥‥‥‥‥‥‥‥ M108M107‥‥‥M104M103 ‥‥M100
Does not change
K1M0
M15 ‥‥‥‥‥‥ ‥‥‥‥‥‥‥M0
0 is stored here
The M3 to M0 data
is stored here
1110101010011101
00001101
M8
M7
When source (S) data is a word device
MOV
D0 K2M100
Destination (D) side
K2M100
01111001
M115 ‥‥‥‥‥‥‥‥‥ M108M107‥‥‥‥‥‥‥‥‥‥M100
Does not change
D0 111010 0111101001
B15 ‥‥‥‥‥‥‥‥ B8 B7‥‥‥‥‥‥‥B0
(Note) The display of the circuit having a digit designation will be as follows.
MOV M0 M100
K1
K2