Filter
Top Products
Integrating SAP DB/MaxDB and Data Protector
Backing Up an SAP DB/MaxDB Database
Chapter 3 285
Figure 3-10 Starting an Interactive Backup
Messages appear in the Results Area as the backup session proceeds.
Upon successful completion of the backup session, the Session
completed successfully message and backup size are displayed.
Running an Interactive Backup Using the Data
Protector CLI
You can start an interactive backup from the Data Protector CLI. Switch
to the /opt/omni/bin (HP-UX systems), /usr/omni/bin (other UNIX
systems) or <Data_Protector_home>\bin (Windows systems)
directory, and run the following command:
omnib -sapdb_list <ListName> [-barmode <sapdbmode>]
[<list_options>] [-preview]
The <ListName> parameter is the name of the backup specification.
The <sapdbmode> parameter specifies the type of the backup.
The <list_options> parameters set the level of the protection, the level
of the network traffic generated by the session, enables writing a CRC
checksum, and disables monitoring of the backup session.
You can select among the following <sapdbmode> backup modes:
{full | diff | trans}
You can select among the following <list_options>:
-protect {none | weeks n | days n | until date | permanent}
-load {low | medium | high}
-crc
-no_monitor