Filter
Top Products
Integrating Oracle and Data Protector
Troubleshooting
Chapter 1 129
Figure 1-25 Checking the Inet Start-Up Parameters:
5. Examine the system errors
The system errors are reported in the
<Data_Protector_home>\log\debug.log file on the Oracle Server
system.
Backup Problems on UNIX Systems
At this stage, you should have performed all the verification steps
described in the previous sections. After this, proceed as follows:
1. Check your Oracle Server configuration
To check the configuration, log in to the Oracle server system as the
user root or as the Oracle user that is identified as described in
“Configuring Oracle Users on UNIX and OpenVMS” on page 21. The
identified Oracle user and the user root must also be added to Data
Protector admin or operator group. Then check the configuration as
described in “Checking the Configuration” on page 33.
2. Verify Data Protector internal data transfer using the
testbar2 utility
Before you run the testbar2 utility, verify that the Cell Manager
name is correctly defined on the Oracle Server system. Check the
/etc/opt/omni/client/cell_server (HP-UX and Solaris systems)