Filter
Top Products
Integrating SAP R/3 and Data Protector
Troubleshooting
Chapter 2 217
Repeat the procedure using SYSOPER instead of SYSDBA. Set the
<ORACLE_HOME> directory
If you are using the recovery catalog:
bin\rman target <Target_Database_Login> rcvcat
<Recovery_Catalog_Login>
If you are not using the recovery catalog:
bin\rman target <Target_Database_Login> nocatalog
If this fails, refer to the Oracle documentation for instructions on how
to set up the password file and any relevant parameters in the
init<ORACLE_SID>.ora file.
Prerequisites on the SAP R/3 Side of the Integration
The following verification steps must be performed in order to verify that
SAP R/3 is installed as required for the integration to work. These steps
do not include Data Protector components.
1. Verify backup directly to disk as follows:
brbackup -d disk -u <user>/<password>
If this fails, check the error messages and resolve possible problems
before you continue.
2. Verify restore directly to disk as follows:
brrestore -d disk -u <user>/<password>
If this fails, check the error messages and resolve possible problems
before you continue.
3. If you are running backups in RMAN mode, verify backup and
restore directly to disk using Recovery Manager channel type
disk as follows:
a. You must define the parameter init in the initialization file
init<ORACLE_SID>.ora.
Run the following commands:
brrestore -d pipe -u <user>/<password> -t online -m all
brrestore -d disk -u <user>/<password>