Filter
Top Products
Integrating Oracle and Data Protector
Troubleshooting
Chapter 1 125
Configuration Problems on UNIX Systems
IMPORTANT If you have encountered any errors up to this point when performing the
procedures described in the previous section, please contact Oracle
support. The respective tests must be done before you even start
checking the Data Protector Oracle configuration.
1. Verify that the Data Protector software has been installed
properly
See the HP OpenView Storage Data Protector Installation and
Licensing Guide for details.
2. Verify that the Data Protector Oracle integration Media
Management Library (MML) is linked with the Oracle
executable
Use the following command to check if the libob2oracle8.sl
(libob2oracle8_64bit.sl) file is linked with the Oracle 8
executable. Note that on HP-UX IA-64 and Solaris systems, the
extension for MML is .so, and on AIX, the extension is .a.
Export <ORACLE_HOME> and <DB_NAME> as described on page 117.
On HP-UX:
/usr/bin/chatr <ORACLE_HOME>/bin/oracle (32-bit Oracle)
/usr/ccs/bin/ldd <ORACLE_HOME>/bin/oracle (64-bit Oracle)
On Solaris:
/usr/bin/ldd -s <ORACLE_HOME>/bin/oracle
On other UNIX:
/usr/bin/ldd -s <ORACLE_HOME>/bin/oracle
On IBM AIX systems:
/usr/bin/dump -H <ORACLE_HOME>/bin/oracle (32-bit Oracle)
/usr/bin/dump -H -X64 <ORACLE_HOME>/bin/oracle (64-bit
Oracle)
On Linux systems:
/usr/bin/ldd <ORACLE_HOME>/bin/oracle