Filter
Top Products
Integrating SAP R/3 and Data Protector
Troubleshooting
Chapter 2230
echo "Test backint called as follows:"
echo "$0 $*"
echo "exiting 3 for a failure"
exit 3
Then start the following commands as the SAP R/3 user; see
“Configuring an SAP R/3 User in Data Protector (UNIX Systems
Only)” on page 165:
brbackup -t offline -d util_file -u <user>/<password> -c
If you receive backint arguments, this means that SAP R/3 is properly
configured for backup using backint; otherwise you have to reconfigure
SAP R/3.
See “Configuring an SAP R/3 Database Server” on page 167.
Configuration Problems
IMPORTANT The procedure described in the previous sections must be performed
before you start checking the Data Protector configuration.
1. Verify that the Data Protector software has been installed
properly.
Refer to the HP OpenView Storage Data Protector Installation and
Licensing Guide for details.
2. Verify that the Data Protector Database Library is linked
with the Oracle executable:
Use the following command to check if the libob2oracle8.so on
Solaris and libob2oracle8.sl (libob2oracle8_64bit.sl) on
HP-UX is linked with the Oracle executable.
Export the <ORACLE_HOME> and the <ORACLE_SID> as described on
page 225.
HP-UX platform:
/usr/bin/chatr <ORACLE_HOME>/bin/oracle