HP (Hewlett-Packard) B6960-96008 Garage Door Opener User Manual


 
Integrating SAP R/3 and Data Protector
Data Protector SAP R/3 Configuration File
Chapter 2162
[-sub[list] <sublist_name>] specifies the sublist in the
configuration file to which a parameter is written to or taken from.
[-local <filename>] specifies one of the following:
When it is used with the -getconf[ig] option, it specifies the
filename for the output of the command to be written to. If the -local
option is not specified, the output is written to the standard output.
When it is used with the -getopt[ion], it specifies the filename of
the file from which the parameter and its value are to be taken and
then written to the standard output. If the -local option is not
specified, the parameter and its value are taken from the Data
Protector SAP R/3 configuration file and then written to the standard
output.
When it is used with the -putopt[ion] option, it specifies the
filename for the output of the command to be written to. If the -local
option is not specified, the output is written to the Data Protector
SAP R/3 configuration file.
NOTE If you are setting the option_value parameter as a number, the number
must be put in single quotes, surrounded by double quotes.
Return Values The util_cmd command displays a short status message after each
operation (writes it to the standard error):
Configuration read/write operation successful.
This message is displayed when all the requested operations have
been completed successfully.
Configuration option/file not found.
This message is displayed when either an option with the specified
name does not exist in the configuration, or the file specified as the
-local parameter does not exist.
Configuration read/write operation failed.
This message is displayed if any fatal errors occurred, for example:
the Cell Manager is unavailable, the Data Protector SAP R/3
configuration file is missing on the Cell Manager, etc.