Mitsubishi Electronics FX3UC Garage Door Opener User Manual


 
849
FX3S/FX3G/FX3GC/FX3U/FX3UC Series
Programming Manual - Basic & Applied Instruction Edition
37 Operation of Special Devices (M8000 -, D8000 -)
37.1 Special Device List (M8000 -, D8000 -)
31
FNC277-FNC279
Data
Transfer 3
32
FNC280-FNC289
High-Speed
Processing 2
33
FNC290-FNC299
Extension File
Register Control
34
FNC300-FNC305
FX
3U
-CF-ADP
35
SFC•STL
Programming
36
Interrupt
Function
37
Special Device
38
Error Code
A
Version Up
Information
B
Execution Times
High-Speed Counter Comparison, High-Speed Table, and Positioning [Positioning is supported in FX3S/FX3G/FX3GC/FX1S/FX1N/FX1NC]
[D]8130
HSZ (FNC 55) instruction:
High-speed comparison table counter
M8130 
[D]8131
HSZ (FNC 55) and PLSY (FNC 57)
instructions: Speed pattern table counter
M8132 
[D]8132 Lower
HSZ (FNC 55) and PLSY (FNC 57)
instructions: Speed pattern frequency
M8132 
[D]8133 Upper
[D]8134 Lower HSZ (FNC 55) and PLSY (FNC 57)
instructions:
Number of target pulses for speed
pattern
M8132 
[D]8135 Upper
D 8136 Lower PLSY (FNC 57), PLSR (FNC 59)
instructions:
Accumulated total number of pulses
output to Y000 and Y001

D 8137 Upper
[D]8138 HSCT (FNC280) instruction: Table counter M8138
[D]8139
HSCS (FNC 53), HSCR (FNC 54), HSZ (FNC
55), and HSCT (FNC280) instructions:
Number of instructions being executed
M8139
D 8140 Lower
Accumulated number of pulses output
from Y000 for PLSY (FNC 57) and
PLSR (FNC 59) instructions.

D 8141 Upper
D 8142 Lower
Accumulated number of pulses output
from Y001 for PLSY (FNC 57) and
PLSR (FNC 59) instructions.

D 8143 Upper
[D]8144 Not used –––––
D 8145
ZRN (FNC156), DRVI (FNC158), and DRVA
(FNC159) instructions:
Bias speed
Default: 0
––––
D 8146 Lower
ZRN (FNC156), DRVI (FNC158),
and DRVA (FNC159) instructions:
Maximum speed
Default in FX1S/FX1N: 100000
Default in FX
1NC: 100000
*1
––
*1
––
D 8147 Upper
D 8148
ZRN (FNC156), DRVI (FNC158), and DRVA
(FNC159) instructions:
Acceleration/deceleration time
Default: 100
––––
[D]8149 Not used –––––
*1. Must be changed to 10000 or less by PLC program.
Number and
name
Content of register
Applicable model
FX
3S
FX
3G
FX
3GC
FX
3U
FX
3UC
Correspond-
ing special
device
FX
1S
FX
1N
FX
1NC
FX
2N
FX
2NC