Mitsubishi Electronics FX3UC Garage Door Opener User Manual


 
52
FX3S/FX3G/FX3GC/FX3U/FX3UC Series
Programming Manual - Basic & Applied Instruction Edition
2 Overview (Sequence Program)
2.7 Types and Setting of Parameters
Registering and changing the entry codes
This section explains the operating procedure of GX Works2, GX Developer.
For the entry code registration/change procedure in FX-10P(-E), FX-20P(-E), FX-30P,
and FX-PCS/WIN(-E), refer to the manual of each product.
1. Set the PLC to the STOP mode.
2. Open New keyword registration dialog box.
GX Works2
Select [Online][Password/Keyword][New...] to open New Keyword Registration dialog box.
GX Developer
Select [Online][Keyword setup][Register...] to open New keyword register dialog box.
3. Set the function selection, keyword input, protection level.
The setting method is different between GX Works2 and GX Developer.
GX Works2
Set item Contents of setting Remarks
Function Selection
Select one of the following.
Keyword Protection(16 digits)
Keyword Protection(8 digits)
Permanent PLC Lock
When "Permanent PLC lock" is selected, it cannot be
reset.
To reset the permanent PLC lock or write programs again
to the PLC, all-clear the PLC memory.
To use two keywords, select "Keyword Protection(16
digits)".
Keyword
Input
Keyword(16 digits)
Input 16 characters. Available
characters are A to F and 0 to 9.
Set 8 characters in the first field, and set 8 characters in
the second field.
Keyword(8 digits)
Input 8 characters. Available
characters are A to F and 0 to 9.
Set 8 characters in the first field.
Retype Keyword Set the same keyword. This input is required for confirmation.
Customer Keyword
Input 16 characters. Available
characters are A to F and 0 to 9.
Put a check mark in the check box "Customer keyword is
used(16 digits)".
Set 8 characters in the former area, and set 8 characters
in the latter area.
Retype Keyword Set a same keyword. This input is required for confirmation.
Protection Level
Select one of the following.
Read/Write Protection
Write Protection
All Online Operation Protection
To select "Protection Level", set "Keyword Protection(16
digits)" or "Permanent PLC Lock" in "Function Selection".