Mitsubishi Electronics A171SHCPUN Home Security System User Manual


 
5. INSPECTION AND MAINTENANCE
5
11
(3) Flowchart when RUN indicator is not lit
Follow the flowchart below if the RUN indicator goes out during operation.
RUN indicator goes out
Is an
error displayed
when a peripheral device
is connected?
Refer to error table.
YES
NO
Reset with the CPU module
RUN/STOP key switch.
RUN indicator
does not light
(1) Defective CPU module
part or contact.
(2) Excessive noise.
Set the CPU module
RUN/STOP switch to STOP.
Write END to address 0 from
a peripheral device.
Set the RUN/STOP switch to
RUN. Operate in monitor
mode from peripheral device.
Contact your nearest
Mitsubishi representative with
details.
RUN indicator
does not light
If (1)
If (2)
Is sequence program
defective?
RUN indicator
lights
Check and correct program.
Connect surge suppressor
circuit (CR, etc.) to noise
source.
RUN indicator
lights