Filter
Top Products
Setup
Leica GS20 Field Guide-1.1.0en
84
1. Power on the GS20 and select 8 Setup, 2 Hardware
Management and the Bluetooth_Wireless Selection.
2. Expand the Wireless tree, expand the Bluetooth, and view
WoRCS.
3. If the GS20 has been linked to the WoRCS Bluetooth
Module, an address that corresponds to the address on
the top of the Bluetooth Module will appear. If the address
does not correspond, press menu and select clear.
4. If the address area displays zeros, you will need to
establish a connection.
5. Highlight the WoRCS branch and press enter; this will take
you to the Bluetooth Setup screen.
6. Press Inquire and wait until the Cancel button becomes
Inquire again.
7. You will see the Available Devices in the choice list. By
highlighting the available devices and pressing Enter, you
will see the entire list of available bluetooth devices in the
choice list. If multiple devices have been found, select the
device that matches your WoRCS bluetooth address,
displayed on the top of the bluetooth module.
8. Finally, press the Menu key and Save, then Escape back
to the main menu.
Tip: Ensure batteries are charged and correctly inserted.
Ensure bluetooth module is set to line and on. The
single flashing red light indicates that power is
available. When the light changes to green a
BLUETOOTH connection is established but no data is
exchanged. When both green lights are flashing data is
exchanged.