Filter
Top Products
XR2500F Installation Guide Digital Monitoring Products
41
WIRInG dIaGRaMs
39.3 Prewired 866 Class B Style W Modules with Multiple Notication Appliances
505-12 Power
Supply
J6
+ DC -
AC
Trouble
Batt
Trouble
J4
J3J2
Green
LED
AC
AC
+ BAT -
Red
LED
DC
12 VDC @ 5 Amps
Battery
Start
The Auxiliary Power Supply and Notification Circuit
Module trouble contact zone must be programmed
as a Supervisory Type zone and must be selected
for display in the keypad status list.
Auxiliary Power Supply must be Listed for Fire
Protective Signaling Service. Power Supplies
must have battery backup.
Listed, Polarized
Notification Appliances
Model 308
10K EOL
Model 308
10K EOL
SM-12/24 Module
Sync module required when using
multiple notification appliances
When using a separate power supply, the
maximum current is 3 Amps.
See the Notification Appliance
section for a list of appliances.
The maximum voltage drop
between the panel Bell Output and
the Model 308 is 1 VDC when a
separate power supply is not used.
The Bell Output
programming for Fire
type zones must be set
to Steady
Model 310
1K EOL
1 AUX PWR
2 GND
3 Alarm In
4 Bell PWR In
5 Bell Out +
6 Bell Out -
7 Bell Trouble
8 Bell Trouble
Normal/Silence Switch
1 AUX PWR
2 GND
3 Alarm In
4 Bell PWR In
5 Bell Out +
6 Bell Out -
7 Bell Trouble
8 Bell Trouble
Normal/Silence Switch
DMP Model 866
45mA @ 12 VDC
The 866 Notification
Appliance Circuit
Module in alarm draws
up to 31mA through
its Terminal 3 Alarm
Input and 45mA from
its Terminal 1 Aux
Power Input.
See the 866
Installation (LT-0059)
Prewired to XR2500F panel
Note: If an
auxiliary power
supply is not used,
Terminals 3 and 4
jumper together to
supply Bell Power
from the panel
SM-12/24 Module