Filter
Top Products
Crestron CLS-C6RF iLux
™
Integrated Lighting System w/infiNET
™
manually adjust this channel after that, you must release and re-press the button.
The unit remains in Lights mode.
To exit Lights mode, press the Lights button again (or press Cancel), and the LED
will go off. The unit is now back in Standard mode. (Also, if no adjustments are
made within one minute, the unit reverts to Standard mode.)
Pressing the Shades button automatically exits Lights mode and enters Shades mode.
Shades Mode
Shades mode allows you to manually control any of the six shade groups.
To enter Shades mode, raise the cover and press the Shades button. The
corresponding LED will light, and now the six function buttons can be used to adjust
shade groups 1 through 6. Any scenes that are currently in the middle of a fade will
immediately go to their target value. The seven white front panel LEDs will go out.
In this mode, these LEDs do not reflect the feedback status of the associated scenes.
When the unit is returned to Standard mode, these LEDs will return to their standard
feedback indication.
• The six function buttons act as open/stop/close/stop (rocker type) for each of the
corresponding six shade groups.
• Operation is as described for the Shade Control button type in Standard mode
(page 33.)
• For shade groups with C2N-SSC-2 controllers:
− While in Shades mode, the bargraphs indicate the current shade position.
− The two-digit display will indicate the current percentage level of the shade
group being adjusted (CL, 01 to 99, OP).
− The two-digit display disappears (goes blank) three seconds after the shade
stops moving (due to either a stop command or reaching a limit of travel).
Note that the two-digit display only shows the shade level when being
adjusted from front panel buttons in Shades mode or scene programming. It
does not display when adjusting levels from a remote panel or Cresnet.
• For shade groups with C2N-SDC or C2N-SDC-DC controllers:
− Bargraphs initially display nothing while a shade is not moving. While the
shade is moving open, the bargraph LEDs scroll in an upward direction.
While moving closed, the bargraph LEDs scroll in a downward direction.
When the shade is stopped or the maximum time is reached, the bargraph
will turn off.
− The two-digit display will show “OP” or “CL” accordingly.
− The up/down button will act as a shades master when in Shades mode, no
matter what function is programmed for it. Pressing the top while the shade
is stopped sends it to full open; pressing the bottom while the shade is
stopped sends it to full close; pressing anything while the shade is moving
stops it. Pressing both while the shade is stopped causes the shade to move
in the opposite direction.
− The ON and OFF buttons on the CLS-C6RF unit itself, will operate
normally while in Shades mode. The same is true for all scene recall or
scene toggle functions triggered by remote panel or Cresnet command.
− Inputs/commands from any remote devices, motion detector, and Cresnet
control system are processed as usual while in Shades mode. If they affect
the group (or groups) being adjusted, the manual adjustment of that shade
Operations Guide - DOC. 6418A iLux
™
Integrated Lighting System w/infiNET
™
: CLS-C6RF • 37