Filter
Top Products
iLux
™
Integrated Lighting System w/infiNET
™
Crestron CLS-C6RF
• Recall-scene (specify scene number OFF, ON, 1-15). Refer to “Recall-scene
buttons” below.
• Toggle-scene (specify scene number ON, 1-15). Refer to “Toggle-scene
buttons” on page 35.
• Lighting master raise/lower (last scene). Refer to “Master (Last Scene)
Raise/Lower buttons” on page 35.
• Lighting master raise (last scene). Refer to “Lighting Master (Last Scene) Raise
buttons” on page 35.
• Lighting master lower (last scene). Refer to “Lighting Master (Last Scene)
Lower buttons” on page 35.
• Shade control (open/stop/close/stop) (specify shade group: AL, 1-6). Refer to
“Shade Control (open/stop/close/stop) Buttons” on page 35.
Recall-scene buttons:
• Used to recall a scene, i.e., have the specified lighting loads and/or shade groups
go to their specified levels in the specified time. (Time only affects lighting
loads; shade time is function of the shade motor.)
− During scene recall, the scene LED flashes until all affected lighting loads
reach their target levels. After this, the LED remains on steady.
− Pressing a scene button while its LED is flashing performs a scene cut
(lights immediately go to target levels).
− When a scene is recalled, the two-digit display will initially show the fade
time of the scene, and then count down to 0 as the scene progresses.
− For the six dual buttons, if the Raise/Lower function is enabled on
Recall-scene buttons via the iLux Designer software, and a scene is selected
(LED on steady), the right and left sides of the function button can be used
to raise and lower all dimmable lighting loads contained in that scene.
− The ON button always acts as a recall scene button for the ON scene,
operating identically to other scene-recall buttons, except that items specific
to dual buttons do not apply.
− The OFF button always acts as a recall scene button for the OFF scene,
operating identically to other scene-recall buttons, except:
1. There is no LED associated with this button. Note that “cut” during
fade will still function. Note also that a feedback LED for an OFF
button on remote keypads will act as all other scene recall LEDs – it
will flash while the off scene is being recalled, and will be lit when the
unit is in the OFF scene.
2. Items specific to dual buttons do not apply.
3. Note that if the last scene recalled was the OFF scene, the last scene
master will affect all dimmable lighting channels (since they are all
included in the “last scene”).
4. Any time all six lighting loads are off, all seven of these LEDs will
glow at a low intensity (to allow finding the CLS-C6RF unit in the
dark).
• iLux
™
Integrated Lighting System w/infiNET
™
: CLS-C6RF Operations Guide - DOC. 6418A
34