Filter
Top Products
Crestron CLS-C6RF iLux
™
Integrated Lighting System w/infiNET
™
Toggle-scene buttons
• Used to alternately recall a scene or turn scene lights off (i.e., have the specified
lighting loads go to off, in the specified time).
• The toggle scene function should not be assigned to any scene that includes
shades.
• Note that the ON and OFF buttons are fixed recall scene buttons, and cannot be
defined to be toggle. (However, a remote keypad button can be defined to toggle
the ON scene, but not the OFF scene.)
• The LED is on if and only if ANY lighting load in the scene is above 0%
(ignores state of shades).
• Pressing the button while all lights are off (LED off) will recall a scene. Pressing
it while any lights are on (LED on) will turn that scene’s lights off.
• During scene recall, the scene LED will flash until all affected lighting loads
reach their target levels. After this the LED will remain on steady until all
affected lights go off.
• During scene turn off, the LED will flash until all affected lighting loads reach
0%. After this, the LED will be off until any affected light turns on.
• Pressing a scene button while its LED is flashing performs a scene cut (during
either recall or turn off).
• Behavior of the two-digit display is the same as for scene recall.
Master (Last Scene) Raise/Lower buttons
• Press the right side to raise lights, the left side to lower, release to stop.
• All dimmable lighting loads will be ramped up or down at a fixed rate, which is
the same rate as used for individual up/down operation in Lights mode.
• Non-dim lighting loads will not be affected.
• The feedback LED will light while the button is being pressed.
Lighting Master (Last Scene) Raise buttons
• Same as Master Raise/Lower button, except that pressing any part of the button
will raise lights.
Lighting Master (Last Scene) Lower buttons
• Same as Master Raise – except lowers lights instead of raising them.
Shade Control (open/stop/close/stop) Buttons:
• Used to control the specified shade group, or all shade groups.
• Press the right side of the function buttons to open the shades; press the left side
to close them. Press the button while the shade is moving to stop it.
• The feedback LED will be on only while a button is pressed.
IR Receiver
Functions can also be triggered through the built in RC5 IR receiver, using the
optional remote control.
Operations Guide - DOC. 6418A iLux
™
Integrated Lighting System w/infiNET
™
: CLS-C6RF • 35