Filter
Top Products
iLux
™
Integrated Lighting System w/infiNET
™
Crestron CLS-C6RF
Connectors, Controls, & Indicators (Continued)
# CONNECTORS,
CONTROLS, &
INDICATORS
CONTROLS, &
INDICATORS
DESCRIPTION DESCRIPTION
16 LOAD1 – LOAD6 Use these terminals to connect the CLS-C6RF
dimmer channel outputs to the appropriate lighting
loads.
17 HOT, NEUTRAL, ((Ground) Use these terminals to connect the unit to the 120V
(CLS-C6RF/MRF) or 230V (CLSI-C6RF/MRF) AC
power source.
18 NOT USED This 4-pin terminal block is not used on the
CLS/CLSI-C6RF & CLS/CLSI-C6MRF.
19 LOCAL DEVICES
G Z Y 24
Use this 4-pin terminal block to connect the
CLS-C6RF, using standard Cresnet wiring, to local
devices. In this configuration, the CLS-C6RF acts
as the Cresnet Master.
Industry Compliance
This product is listed to applicable UL Standards and requirements by Underwriters
Laboratories Inc.
(E103692)
As of the date of manufacture, the CLS-C6RF has been tested and found to comply
with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling.
NOTE: This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
• iLux
™
Integrated Lighting System w/infiNET
™
: CLS-C6RF Operations Guide - DOC. 6418A
8