iLux
™
Integrated Lighting System w/infiNET
™
Crestron CLS-C6RF
• When acquire is done, the display will alternate between “Ac” and result codes.
• If acquire was successful, the save led will flash, and the Cancel led will turn
off. (Cancel button is disabled). Press the Save button to go into Standard
mode.
• If acquire was unsuccessful, the Cancel led will flash. The previous gateway
link information will be restored. Press the Cancel button to go into Standard
mode.
Result codes:
“00” = Successful
“E1” = Cannot communicate with the transceiver
“E2” = Search expired; no gateway found
“E3” = RF channel is disabled. This code is immediately shown when the Acquire
mode is entered.
“E4” = Invalid EUID or EUID was not assigned
Unacquire Gateway (UA)
This procedure is used to unacquire the C2N-MNETGW gateway.
• To do this, enter Setup mode and scroll to the “UA” option, using the ^ and v
buttons.
• Press and hold the up/down button for five seconds. The “UA.” text will flash,
the Save and Cancel leds will flash.
• If “Unacquire” is successful, the Save led will flash. The display will alternate
between “UA” and the passed result code. Press the Save button to end Setup
mode and enter Standard mode
• If “Unacquire” is unsuccessful, the Cancel led will flash. The display will
alternate between “UA” and the failed result code. Press the Cancel button to
end Setup mode and enter Standard mode.
Result codes:
“00” = Successful
“E1” = Cannot communicate with the transceiver
“E2” = Unacquire failed (1-was never acquired, 2-etc.)
Display/Set RF Channel
This procedure is used to display or set the RF Channel.
• To do this, enter Setup mode and scroll to the “Ch” option, using the ^ and v
buttons.
• Press the master up or down key. The current channel is shown. The Channel
mode is now locked. A dot will be shown to the right of the “Ch”. The display
will alternate between “Ch.” and the current channel.
• If the button is held for more than ½ second, the unit will auto-repeat and start
scrolling through the values. At the upper or lower limit, the unit will pause for
½ second and then wrap around.
• Use the up/down key to change channel. If held for more than ½ seconds will
auto repeat. At limit will pause for ½ second and then wrap around
• Press the Save button to save the new value and return to Standard mode.
• iLux
™
Integrated Lighting System w/infiNET
™
: CLS-C6RF Operations Guide - DOC. 6418A
22