Filter
Top Products
iLux
™
Integrated Lighting System w/infiNET
™
Crestron CLS-C6RF
When the button is released, the LED for that button should flash once to
indicate that programming took place.
2. Next, use the up/down button to scroll to the next function and value to be
assigned, and assign the desired buttons. Repeat this procedure for each
function and value to be assigned.
3. After assigning all button functions, press Save, and the button function
information will be saved. If you press Cancel, or exit by some other
mechanism (e.g., timeout), the state will return to what it was before you
entered Setup mode.
• Note that the ON and OFF buttons on the CLS-C6RF cannot be programmed.
The operation of the up/down button is programmed using the “ud” setup
function.
• If you try to program an illegal button (e.g., the ON button, or program a remote
keypad button as master raise/lower-up/down), LED will flash on three times to
indicate that setting did not take place, and the two-digit display will show “Er.”
• Note that other button functions, including “shifted” functions, can be defined
using the iLux Designer configuration program.
Setup Up/Down Button Function (ud)
To define operation of the up/down button, enter Setup mode and scroll to the “ud”
option (using the ^ and v buttons).
• Use the up/down button to select the desired mode. The display will flip
between “ud.” and “#”, where # is the mode, as defined in the following table.
FUNCTION MODE
Lights (Last Scene) Master Up/Down L
Shades Master Up/Down S
• The first function to be displayed will be the current function. Since there are
other functions that can be programmed via the iLux Designer, if the current
function is not one of these, the display should show “ud.—”. Pressing the
up/down button will then go to mode L.
• Press Save to save the new setting or Cancel to retain the original setting.
Setup Occupancy Sensing (oc)
To define operation of the Occupancy Sensing feature, enter Setup mode and scroll
to the “oc” option (using the ^ and v buttons).
• Use the up/down button to select the desired mode. The display will alternate
between “oc.” and the mode number, as defined in the following table.
MODE CODE
Do nothing on either exit or entry 0
Recall specified scene on exit, do nothing on entry 1
Recall specified scene on entry, do nothing on exit 2
Recall specified scenes on entry and exit 3
• The first mode to be displayed will be the current mode.
• iLux
™
Integrated Lighting System w/infiNET
™
: CLS-C6RF Operations Guide - DOC. 6418A
18