Filter
Top Products
60
Utility
Stitches
Characters
and
Decorative
Stitches
Embroidering
Editing
Embroidery
Patterns
Retrieving
My
Custom
Stitch
TM
Maintenance
Error
Messages
Trouble
shooting
Sewing
Chart
Patterns
(Programmed
in Machine)
Patterns
(Memory
Card)
Sewing
Setting Up
1
2
3
5
4
4
1. Set the stitch length using the scale on presser foot “A”.
1 Scale on the presser foot
2 Button holder plate
3 5 mm (3/16”) at “2” on scale
4 Length of darning is equal to scale setting.
5 Width [7 mm (1/4”)]
* The maximum stitch length for darning is 3 cm (1-3/16”).
5
3
2. Check the needle drop point and then lower the presser foot.
* After the presser foot lever has been lowered,
set the presser foot so that there is no gap
behind the section marked with an “A”, otherwise
the size of the stitch will not be correct. To do
this, push the presser foot towards the back of
the machine as shown in the left figure.
* Pass the thread underneath the presser foot.
5
3
5
3
1
4. Start sewing while holding the upper thread by hand.
* The machine stops automatically after sewing a reinforce-
ment stitch.
* When automatic thread cutting is set, the machine trims
both threads automatically after sewing is completed.
3. Lower the button hole lever to set it behind the metal
bracket.
1 Metal bracket
A
DARNING
1 Medium fabric
2 Thick fabric
A
12