Filter
Top Products
47
Utility
Stitches
Characters
and
Decorative
Stitches
Embroidering
Editing
Embroidery
Patterns
Retrieving
My
Custom
Stitch
TM
Maintenance
Error
Messages
Trouble
shooting
Sewing
Chart
Patterns
(Programmed
in Machine)
Patterns
(Memory
Card)
Sewing
Setting Up
ADAPTER FOR LOW SHANK ATTACHMENTS
This adapter is used for attaching screw-on presser feet to this machine. Following is explanation about
installation of walking foot.
This foot is very useful for sewing materials such as vinyl cloth, synthetic leather, thin leather, etc. These
materials are difficult to be fed when sewing but this foot can prevent such materials from crumpling,
slipping or sticking between presser foot and materials thanks to even feeding upper and lower materials.
You can use walking foot only for sewing STRAIGHT STITCH (
· ) and ZIGZAG STITCH ( ).
You can not use this foot for sewing other patterns including horizontal feed (STRAIGHT & ZIGZAG
STITCH).
1
2
3
1 Adapter
2 Screw (small) *
3 Screw (large) **
Included accessories
5
3
*
**
1
1. Remove the presser foot and the presser foot holder.
2. Attach the adapter for low shank attachments.
* Push the adapter up onto the end of the presser bar as far
as possible.
* Use the metal disk provided with your machine (accessory
#14 on page 7) or screw driver to tighten the screw (small)
firmly.
*
When attaching the adapter, be sure to use the metal disk
or screw driver to tighten the screw firmly. If the screw is not
completely tightened, injuries may occur.
3. Fix the connecting lever of Walking foot to the needle fixing
screw and install Walking foot onto the presser bar. Lower
the presser foot and tighten the presser foot holder screw
(large).
**
Before sewing, be sure to turn the balance wheel toward
you slowly to check that the needle does not touch the
presser foot, otherwise injuries may occur. Please sew with
slow to medium speed.
Installation of walking foot
1 Connection lever