Filter
Top Products
54
Utility
Stitches
Characters
and
Decorative
Stitches
Embroidering
Editing
Embroidery
Patterns
Retrieving
My
Custom
Stitch
TM
Maintenance
Error
Messages
Trouble
shooting
Sewing
Chart
Patterns
(Programmed
in Machine)
Patterns
(Memory
Card)
Sewing
Setting Up
BUTTONHOLE STITCHES
1 Suits, overcoat
2 Jeans, trousers
3 Thick coats
4 Thin or medium fabric
5 Stretch fabric with coarse
weaves
6 Stretch fabric
7 Thin and medium fabric
(for horizontal holes)
8 Jeans, trousers
9 Thick coats
0 The first step in making a
bound buttonhole.
A
1234 5
6789 0
1. Mark the positions of the buttonholes on the fabric.
* The maximum buttonhole length is 3 cm (1-3/16”) (total of
diameter + thickness of button).
* Thick thread (#30) cannot be used in with the “ ” and
“ ” patterns.
5
3
2. Draw out the button holder plate and insert the button.
1 Button holder plate
A
5
1
5
3
3. Raise the presser foot and adjust the fabric so that the red
mark on the foot is over the starting mark of your buttonhole.
Lower the presser foot into position.
1 Mark on fabric for buttonhole position
2 Red mark on presser foot
* After the presser foot lever has been lowered,
set the presser foot so that there is no gap
behind the section marked with an “A”, otherwise
the size of the stitch will not be correct. To do
this, push the presser foot towards the back of
the machine as shown in the left figure.
* Pass the thread underneath the presser foot.
4. Lower the buttonhole lever and position it behind the metal
bracket on the buttonhole foot.
1 Metal bracket on the buttonhole foot
A
1