Filter
Top Products
58
Utility
Stitches
Characters
and
Decorative
Stitches
Embroidering
Editing
Embroidery
Patterns
Retrieving
My
Custom
Stitch
TM
Maintenance
Error
Messages
Trouble
shooting
Sewing
Chart
Patterns
(Programmed
in Machine)
Patterns
(Memory
Card)
Sewing
Setting Up
BAR TACKING
Use for reinforcing the openings of pockets, etc.
A
4
3
2
1
1. Attach presser foot “A” and set the size by measuring the
area to be bar tacked.
1 Button holder plate
2 Scale
3 0.5 cm (3/16”)
4 Length of bar tack
* 0.5 to 3 cm (3/16” to 1/2”) is suitable for bar tacking. 0.5 to 1
cm (3/16” to 3/18”) is the normal size.
5
3
2. Position the pocket as illustrated with the top of the pocket
facing you. Stitch down the pocket following the pattern
instructions. To secure the pocket with bar tacking align the
needle drop point with the corner of the pocket to be
stitched and move the pocket back 2 mm (1/16”) as shown
below.
* After the presser foot lever has been lowered,
set the presser foot so that there is no gap
behind the section marked with an “A”, otherwise
the size of the stitch will not be correct. To do
this, push the presser foot towards the back of
the machine as shown in the figure.
* Pass the thread underneath the presser foot.
5
3
1
3. Check the first needle drop point and lower the presser foot.
1 2 mm (1/16”)
4. Lower the buttonhole lever and position it behind the metal
bracket on the buttonhole foot.
1 Metal bracket on buttonhole foot
A